The debug IP address of an Xbox / Xbox 360 running a debug dashboard (such as XDK) may be entered in here. <Auto> will detect any XBOX consoles and attempt to connect to them. XBOX 360 consoles do not support the auto-detect feature and therefore must be manually entered.
By default set to "<Auto>"
After entering a debug IP address (or <Auto>) this will attempt to connect to console running a debug dashboard.
If using two seperate connections (such as WiFi for internet & a cross-over cable plugged into the LAN port) and you are experiencing connection issues, try turning off your WiFi and attempt to connect again.
If issues are still present, try disabling any firewalls that may be blocking communications.
Debug / RTH requires the use of Port 731 to be opened.
Used to end communications with the given debug box.
Once connected to a debug box, Auto-Load Map will examine map characteristics to attempt to match the currently loaded map on the debug box to any maps in your map directory and open the matching map.
Shows "[Not Connected]" until a debug box has been connected to, then displays the debug box name.
This performs a soft (warm) reboot of the debug box.